You will need to connect a 3-Wire Jumper Cable (Y) to each of the Line
Follower Boards (Q). Note the color of the wire attached to each pin.
Line Follower Connections:
Jumper Wire Color
RedBot Sensor - Line Follower
Black
GND
Red
VCC
White
OUT
Attach all 3 cables to the 3 Line Follower Boards. Notice that the white wire
should be on the right and the black wire should be on the left.
Locate the wide, rectangular slot near the front of the chassis and snap the
line follower assembly in from the bottom side of the chassis. Route the
cables through the large hole in the bottom plate.
Read on if you have the SIK for RedBot or are using the Mechanical
Bumpers. If not, skip to the next section.
One of the sensors included in the SIK for RedBot are a set of Whisker
