2
4
CLEANING AND
MAINTENANCE
WARNING: Turn off fireplace
and let cool before cleaning.
CAUTION: You must keep
control areas, burner and cir-
culating air passageways of
fireplace clean. Inspect these
areas of fireplace before each
use. Have fireplace inspected
yearly by a qualified service
person. Fireplace may need
more frequent cleaning due to
excessive lint from carpeting,
bedding material, pet hair, etc.
WARNING: Failure to keep
the primary air opening of
the
burner clean may result in
soot-
ing and property damage.
BURNER INJECTOR HOLDER AND
PILOT AIR INLET HOLE
________
Ports
________
Burner
Tube
________
Primary
Air Inlet
Holes
________
Figure
21
- Injector Holder On Outlet
Burner Tube
Figure
22
- Pilot Inlet Air Hole
P
rimary Air Hole(s)
Orifice
_______
_
3. Blow air through the ports and holes in
the burner.
4. Check the injector holder located at the end
of the burner tube again. Remove any large
particles of dust, dirt, lint or pet hair with a
soft cloth or vacuum cleaner nozzle.
5. Blow air into the primary air holes on the
injector holder.
6. In case any large clumps of dust have now been
pushed into the burner repeat steps 3 and 4.
Clean the pilot assembly also. A yellow tip on the
pilot flame indicates dust and dirt in the pilot as-
sembly. There is a small pilot air inlet hole about
two inches from where the pilot flame comes out
of the pilot assembly (see Figure 22).
With the unit off, lightly blow air through the air
inlet hole. You may blow through a drinking straw
if compressed air is not available.
The primary air inlet holes allow the proper amount
of air to mix with the gas. This provides a clean
lint and pet hair. Clean these air inlet holes prior to
burning flame. Keep these holes clear of dust, dirt,
each heating season. Blocked air holes will create
soot. We recommend that you clean the unit every
three months during operation and have heater
inspected yearly by a qualifed service person.
We also recommend that you keep the burner
tube and pilot assembly clean and free of dust and
dirt. To clean these parts we recommend using
compressed air no greater than 30 PSI. Your local
computer store, hardware store or home center
may carry compressed air in a can. You can use a
vacuum cleaner in the blow position. If using com-
pressed air in a can, please follow the directions on
the can. If you don't follow directions on the can,
you could damage the pilot assembly.
the unit to cool for at least thirty minutes.
1. Shut off the unit, including the pilot. Allow
2. Inspect burner, pilot and primary air inlet
( see Figure 21).
holes on injector holder for dust and dirt
