Spar SP-800A, Инструкция по эксплуатации

Страница: 7 / 12

FITTING THE MIXING TOOL
Slide the bayonet fitting of the tool onto the
PLANETARY SHAFT
and twist
clockwise to secure it in position.
To remove the mixing tool, slides the tool up the
PLANETARY SHAFT
slightly and
twist counter clockwise. Please see figure 3.
CONTROLS
!
"
CAPACITY
Please refer to Page 8.
The table lists the recommended capacities of finished weights of regular mixes.
Although the machine may be capable of mixing larger quantities, it will lead to excessive and premature
wear and possible failure. Overloading also results in lengthy processes and unsatisfactory results.
SPEED SELECTION
Before changing speeds, the mixer must always be stopped. The necessary speed can then be selected
before restarting the machine by pressing the red start button.
The speed selected depends largely on the quantity and consistency of the product. It is recommended
that mixing is always started at the lowest speed and progressively increased to the desired speed. In an
emergency situation always use the red emergency stop button to stop the machine.
Table 2 shows the recommended speeds for the range of tools.
Recommended Speed
1st gear 2nd gear 3rd gear
Whisk
Beater
Hook
Note: After cleaning, please wipe the shaft with Vaseline or oil for
better lubrication and preventing rust.
#