Spar SP-800A, Инструкция по эксплуатации

Страница: 6 / 12

CORRECT USE OF THE MIXER
It is the responsibility of the users to use the mixer correctly within the recommended limitations.
Always follow the instructions on the side of the machine when changing speed.
If the motor labors, stop the machine and reduce the size of the mix immediately. Damage resulting
from improper use is not covered by the SPAR warranty.
For operator safety, the machines is fitted with a bowl guard which is electrically interlocked to ensure
that the mixer cannot operate unless the guard is correctly positioned and the bowl is raised.
For additional safety the mixer has a no volt release feature which means that in the event of a power
failure, the machine will only restart after the control arrangement ensures that when the supply is restored,
the machine cannot restart on its own.
TOOL SELECTION
The beater, whisk and spiral dough hook are meant
for the work implied by their names.
Do not use the beater for dough making or the whisk
for anything other than whisking, aerating or mixing light
mixtures.
Table 1 shows the typical uses for each tool.
BOWL LIFT & BOWL GUARD
The BOWL CRADLE and BOWL GUARD are electrically interlocked. The machine will only
operate with the bowl cradle in the raised position. In addition to this, the bowl guard must be placed into
position by aligning the mark
V cut into the safety guard with the small raised portion on the lip of the
bowl. Only once the bowl is raised and the bowl guard is fitted, the machine can be operated. This safety
function ensures total user safety at all times. Once the bowl guard has been opened or the bowl lowered,
the machine will be shut off immediately.
During the mixing process additional ingredients can be added by means of the chute located on the
right hand side of the bowl guard.
FITTING THE BOWL
With the bowl cradle lowered, place the chosen mixing tool in the bowl and
position the bowl on the cradle. There are three location points for the bowl:
(1) The locking pin at the rear of the bowl should locate in the hole of the cradle.
(2) The two holes in the bowl handles must engage on the pins located on the
cradle.
(3) Latching the bowl locking.
Please ensure that the bowl is seated correctly on the cradle before securing
the bowl locking latches prior to use.