5
Step 3:
Affi x module to cabinet
Once the ideal location has been determined,
mark a position to drill a 16mm hole to feed
the RJ data cable through the cabinet to allow
you to connect the SmartLink module to your
SV Series spa control (a 16mm spade drill bit
is recommended). Once the cable has been
fed through the cabinet, peel off the adhesive
backing and affi x module to cabinet. Then
screw the backing plate to the cabinet using
the screw holes as indicated aside (Fig 3).
Re-attach front cover and tighten front cover
screw.
NOTE:
DO NOT overtighten backing
plate mounting screws
.
If the screws are
overtightened the backing plate may bend
and prevent the front cover from sealing on
the waterproof gasket when re-attached
Step 4:
Connect data cable to SV spa control
The SmartLink RJ data cable MUST be connected to the
EXP1 (Expand Port 1)
socket
on your SV spa control. The module CANNOT be connected to any other socket. The
EXP1
socket can be found in the top right-hand corner of your SV Series spa control, or
on the top right side of the main PCB on your SV Mini spa control once the cover has been
removed.
SV Series - EXP1 socket location
SV Mini - EXP1 socket location
Fig. 3