a
a
a. Coat inside of agitators (if present) with
Spaceman lubricant and install with arrow
poin ng up.
b. Install internal and front drip trays.
c. If machine will be le unused, install air
tubes and place hopper lids on top;
otherwise, set air tubes aside un l a er
machine has been primed.
5. I
,
,
b
c
IMPORTANT:
A er sani zing the machine, DO NOT rinse or touch areas that have been sani zed.
Product must be added immediately. If new product will not be added immediately, rinse machine
with clean water and loosen door hand-screws to allow cylinders to air-dry. Sani ze machine before
using again.
1. Verify assembly is complete.
2. If installed, remove hopper covers and air
tubes.
3. Verify draw valves are in the CLOSED
posi on (UP).
4. Mix a minimum of 8 liters (2.11 gallons) of
food-grade sani zer in a bucket or
container.
5. Pour half the food-grade sani zer solu on
into each hopper.
6. Turn power switches ON.
7. Press RESET bu on; press WASH bu on to
begin cycle. Allow solu on to agitate for 5
to 10 minutes;
NEVER leave machine on
WASH for more than 10 minutes.
8. While
agita ng, gently use a clean brush to
scrub and distribute sani zer solu on along
hopper walls.
9. Place a bucket or container below the draw
valves; OPEN the draw valves (DOWN) and
drain solu on from the machine.
10. Press RESET bu ons to stop cycle.
3
4
9
4
5
CAUTION:
Always use food-grade, no-rinse sani zer to sani ze. If warm water is required to dissolve
sani zer, allow the solu on me to cool before adding to machine.
8
1
2
2
6
7
10
c
11
P
:
S
Before opera ng the machine, it is required that the operator know the func on of each opera ng control.
M L
I
˖
A mix level indica ng light is located at the front of the machine. When the light is
“ON”, it indicates that the mix hopper has a low supply of mix and should be re
fi
lled as soon as possible.
Always maintain at least 2cm of mix in the hopper. If you neglect to add mix, a freeze-up may occur. This will
cause eventual damage to the beater assembly, the dispensing door, and gear box.
D
S
˖
During normal opera on the display is used to indicate func on, the temperature of the
mix in the hopper and cylinder, the electric current of beater motor, error, and warning message.
T
S
P
˖
To be er communicate in the Interna onal arena, symbols have replace words on
many of your operator switches. SPACEMAN equipment is designed with these interna onal symbols.
1
2
3
4
5
6
Turn on power
Press and hold RESET for 3 seconds to enter into
Menu; Press RESET to turn to next page
M
D
I
Mix Low Indicator
Touch Switch Panel
Display Screen
Press RESET bu on
to turn to STOP
mode
Press WASH bu on
to turn to WASH
mode
Press P bu on,
displays tempera-
ture of Hopper &
Cylinder
Press STANDBY
bu on to turn on
STANDBY mode
Press FREEZE bu on
to turn on FREEZE
Mode
Press ICE CREAM
bu on, screen dis-
plays dispense count
Press P bu on
again, displays
motor current
Viscosity Se ng
Hopper Temperature
Date & Time
12
O
C
:
I
1. FREEZE
B
2. WASH
B
3. STANDBY
B
4. RESET
B
5. ICE CREAM B
6. P
B