SAFETY PRECAUTIONS
15.
The device may be connected only to alternating current power grid, listed in this document.
16.
Never put the device in water or any other liquid. Do not use the device in close proximity to baths, showers,
water filled containers or in very humid places or places where aerosols or oxygen are used, since this might be
dangerous even when the device is turned off. For these reasons, keep the device unplugged when not used.
17.
Do not use the device if it has been physically damaged, after dropping it or in case its power cable has been
damaged. If the device has broken down or is malfunctioning, it needs to be turned off. Do not attempt to repair
the device on your own. Contact the authorized service in order for the device to be repaired by a qualified expert.
18.
If the power cable is malfunctioning or damaged, contact the authorized service immediately in order for it to be
replaced.
19.
Unplug the device before cleaning it.
20.
Do not wrap the power cable around the device.
21.
Do not turn the device off by pulling the power cable or the device itself.
22.
Do not touch the device with wet hands or feet.
23.
Do not use the device while barefoot.
24.
Keep the device away from children, individuals with psycho-physical impairment and those who are taking a
bath or a shower.
25.
As an additional protection measure, installation of a residual current device (RCD/FID) with a rated residual
operating current not exceeding 30mA is advisable. This household faulty current protection device may only be
installed by an expert (electrician).
26.
Once hot, do not put the heater on any soft surfaces such as beds, carpets or towels. Place the hot device only on
solid, flat, thermal-resistant surfaces.
27.
Do not use any extension cords in rooms with bathtubs or showers.
28.
No liability will be accepted for any damage caused by inadequate handling of the device or by not following the
instructions stated herein.
USAGE INSTRUCTIONS
Before usage, read the instructions carefully and save the document for later use and reference. Contact the
distributor in case of any doubts regarding device usage.
Usage:
10.
Make sure the skin is completely clean before usage.
11.
Install the cartridge into the device.
12.
Plug the cable into the device and plug the device into the power outlet.
13.
Before usage, heat the wax for 20-30 minutes.
14.
Apply the product in the direction of hair growth, covering the surface of 15-18 cm
2
. Before applying,
check whether the temperature of the wax is suitable for usage. If the wax is too hot, wait for it to cool
down before application.
15.
After applying the wax, set the depilation strip onto the wax and hand press it, in the direction of the
hair growth.
16.
Remove the depilation strip, starting from against the hair growth direction.
17.
After depilation, remove all residue using wax removal products.
18.
After removing the wax residue, massage the treated area using after-depilation oil.
Caution:
Unplug the device before cleaning it.
Do not apply on sensitive or problematic skin.
Do not expose the skin to UV rays 24 hours after the treatment.
Use only soft cloth soaked only with wax removal, device cleaning product. Do not submerge into water.
