BIOS Setup Utility
SY-K7VIA
70
3-5.4 FDC Controls
FDC Controls
Setting
Description
Note
Disabled
Turn off the on-board
floppy controller
Onboard FDD
controller
Enabled
Use the on-board floppy
controller
Default
3-5.5 Onboard Serial Ports
Onboard Serial
Ports
Setting
Description
Note
Disabled
3F8/IRQ4
Default
(port 1)
2F8/IRQ3
Default
(port 2)
3E8/IRQ4
2E8/IRQ3
Onboard
Serial Port 1 /
Serial Port 2
Auto
Choose serial port 1 & 2's I/O
address.
Do not set port 1 & 2 to the
same address except for
Disabled or Auto.
Standard
Default
HPSIR
UART 2 Mode
ASKIR
The second serial port offers
these InfraRed interface
modes.
If [UART 2 Mode] is set to [IrDA]/[ASKIR]
Half
Default
IR Function
Duplex
Full
Choose [Half] or [Full]
Duplex to set UART2 in half
duplex mode or full duplex
mode respectively. Refer to
your IR device specifications
to select the suitable mode.
No,Yes
Default
TX,RX inverting
enable
No, No/
Yes, No/
Yes, Yes.
This item allow you to enable
the TX, RX inverting which
depends on different H/W
requirement. To avoid any
error to your system, it is
recommended to leave it to its
defaults setting.
Содержание SY-K7VIA
Страница 97: ...93 ...