Soyer BMK-10i, Руководство по эксплуатации

Страница: 38 / 74

38 Operating manual Soyer Bolzenschweißtechnik
With this stud welding gun the earth connection is integrated in the gun, in front of the
support tube insert. A separate earth connection is not needed on the workpiece.
The gun has a lift magnet. Before welding, the stud is lifted by the lift magnet and
automatically lowered again for welding.
The height of the lift is also crucial for the weld result.
The lift height can be determined using the lift time with the aid of the stud welding
device. To do so, observe chapter
“12.1.5 Setting the lift time (height of lift) in the "Setup"
mode
” on page 62.
The height of lift is set using the adjusting wheel on the gun (see "Figure 5: PH-9
SRM
12
+G stud welding gun").
The PH-9 SRM
12 +G stud welding gun has a gas insert for each diameter of the stud
chuck:

M6: F06738

M8: F06739

M10: F06740

M12: F06741
The gas insert serves to optimise the gas flow and insulate the stud chuck from the
shielding gas cap.
The PH-9 SRM
12
+G stud welding gun may only be operated with the stud
welding devices specified in the technical data.