3
2.
Installation
1. Select a location for the AR-716Ei unit that is secure and sheltered from weather and
extreme humidity. Choose a location that facilitates access to power and is
reasonably close to the doors that are to be controlled.
2. Using the unit as a template, mark on the mounting surface the location of the two
mounting holes.
3. Install appropriate mounting hardware (anchors, retainers, etc.) to the mounting
surface if necessary.
4. Screw mounting screws into the top 2 mounting holes of the mounting surface,
leaving about 0.4 cm clearance. Place panel top key-way mounting holes over
installed mounting screws and slide panel down.
5. Route cables into the enclosure through knockouts in sides, top or bottom of box,
being careful not to nick or scrape insulation on any rough edges.
CAUTION SHOULD BE TAKEN NOT TO TOUCH CIRCUIT BOARD OR
ELECTRONIC COMPONENTS PRIOR TO AND DURING INSTALLATION TO AVOID
ELECTRO-STATIC DISCHARGE (ESD) DAMAGE.
Wall Surface
Use Appropriate Fasteners
