13
5.5.2 Get IP address by DHCP Server:
AR-727i support Auto Configuration of the IP and gateway addresses and subnet
mask function, but must make sure the DHCP Server is active. The steps as follows:
Step 1: Power off.
Step 2: PCB diagram as follows by using DHCP Function.
Switch DIP SW-1 to “ON” position.
Switch DIP SW-2 to “OFF” position.
Switch Jumper j2,J3, J4 and J5 to Net position.
No IC Chip in the U3 position.
Step 3: Power on. In begging state the ACT LED will flashing, after IP has got ACT
LED will off and auto save the new IP address to EEPROM.
Step 4: Power off.
Step 5: Change communication IC Chip from the “U2” position to the “U3” position.
Step 6: Then, Switch DIP SW-1 to “OFF” position and Switch DIP SW-2 to “ON”
position. ( return to Serial Setup Mode)
Step 7: Connect AR-801CM to the HOST of the PCB.
Step 8: Power on.
Step 9: To modify parameter on the AR-727i through the Hyper-Terminal function of
the Window.
(Start
→
Programs
→
Accessories
→
Communication
→
Hyper Terminal)
