Sovereign BBQs & Grills Australia
Phone (Intl +61 7) 5644 1230
Fax (Intl +61 7) 5519 3529
Web: www.sovereignbbqs.com
Email: [email protected]
Burner Removal
Burners should be removed periodically and cleaned with warm soapy water. Ensure the burner is
totally dry before reassembly, which may take some time (preferably dry your burner in the sun, but
exercise caution as it may become very hot to touch).
To remove the burner:
(1)
Remove the semi-permanent Oven Wire by unscrewing the retaining screw and sliding it out of
the rear keeper holes.
(2)
Unbolt the thermocouple (copper tube with probe end, adjacent the Piezo lead) securing nut on the
face side of the thermocouple locator bracket to allow the burner to side out (the second rear nut, at
the back of the thermocouple locator bracket, can be left as is).
(3)
Lift the left end of the burner up and out of the securing clip.
(4)
Slide to the left, off the gas control valve and out of the thermocouple locator, and lift out.
The below diagrams will assist you in removing the burner from your selected Sovereign BBQ.
Ancillary Service Information
Your BBQ should be serviced at 12 month intervals (or sooner as required) by an authorised gas
technician to ensure its ongoing safe operation. Note that the burner (flame) should always burn blue
with only a small amount of yellow at the peak. If abnormal gas smells are present, turn off all
controls and the gas supply point, then have your BBQ checked immediately by a qualified gas
technician.
Do not modify this appliance in any way.
