PALLETPAL SPRING OWNER'S MANUAL
9
Installation Instructions
Unpacking the Unit
1. Before you start to install the unit, check for local codes
and ordinances which may apply. It is your responsibility to
obtain any necessary permits.
2. Please read all of these instructions carefully. Be sure
to read and understand all of the warnings.
3. Inspect the shipping pallet carefully for any damage
which may have affected the unit. If you see signs of dam-
age, tell the trucker. Also make a note of this on the shipping
papers which you are asked to sign.
4. Choose the place where you want to use the unit. It is
very important that the PalletPal be set up on a smooth and
flat surface. Check the floor surface carefully and make sure
that it is free of all loose debris and dirt.
Using optional adjustable feet, the unit can compensate
for a slightly sloping floor (1:25), but the surface must be
smooth and solid.
CAUTION!
The unit must be installed on a smooth flat
surface. If the floor is not flat, this can create
stresses in the frame of the unit. The unit may
not work properly, or parts of the unit may wear
more quickly than they should. You may be hurt
or the load may be damaged.
5. Position the PalletPal beside the point where the unit
will be set up.
WARNING!
The unit is attached to the skid using metal
bands. These bands are under high tension.
The edges are sharp. Wear safety glasses and
gloves when you handle or cut the banding.
Table 1 - Spring selection chart
