Southwire 23090T MaintenancePRO Скачать руководство пользователя страница 4

Страница: 4 / 20

Span.

Potential danger. Indicates the user must refer to the manual for important safety information
Indicates hazardous voltages may be present

Equipment is protected by double or reinforced insulation

Indicates the terminal(s) so marked must not be connected to a circuit where the

voltage with respect to earth ground exceeds the maximum safety rating of the meter

Indicates the terminal(s) so marked may be subjected to hazardous voltages

MAX

1000V

International Safety Symbols

Brief Description

Typical Applications

Category Rating

Single phase receptacles

and connected loads

Three phase circuits and

single phase lighting

circuits in commercial

buildings

- Household appliances, power tools

- Outlets more than 30ft (10m) from a CAT III source

- Outlets more than 60ft (20m) from a CAT IV source
- Equipment in fixed installations such as 3-phase

motors, switchgear and distribution panels

- Lighting circuits in commercial buildings

- Feeder lines in industrial plants

- Any device or branch circuit that is close to a CAT III source

CAT II

CAT III

The measurement category (CAT) rating and voltage rating is determined by a combination of the meter, test probes and any

accessories connected to the meter and test probes. The combination rating is the LOWEST of any individual component.

CAT IV

Connection point to

utility power and

outdoor conductors

- Primary distribution panels

- Overhead or underground lines to detached buildings

- Incoming service entrance from utility

- Outdoor pumps

Safety Category Ratings

FCC COMPLIANCE

Users of this product are cautioned not to make modifications or changes that are not approved by

Southwire Company, LLC. Doing so may void the compliance of this product with applicable FCC requirements

and may result in the loss of the user’s authority to operate the equipment.

This device complies with Part 15 of the FCC rules and with RSS-247 of Industry Canada. Operation is subject to the

following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any

interference received, including interference that can cause undesired operation.

FCC Digital Emissions Compliance

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of

the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential

installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in

accordance with the instructions, may cause harmful interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference

to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged

to try to correct the interference by one or more of the following measures:

• Reorient or relocate the radio or television receiving antenna.
• Increase the separation between the computer equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the radio or television receiver is connected.
• Consult the dealer or an experienced radio television technician for help.
FCC ID:2AENI-23090T

Canadian Digital Apparatus Compliance

IC:20144-23090T
CAN ICES-3 (B)/NMB-3(B)

,ZWLJPÄJHJPVULZ

cont.

500.00nF
5000.0nF
50.000µF
500.00µF
5.000mF

Protección de Entrada:

600V AC rms o 600V DC

10pF
0.1nF
1nF
10nF
1µF

±(3.5% +40 dígitos)

±(5.0% +10 dígitos)

Capacitancia
(Rango Automático)

50.000Hz
500.00
5.0000kHz
50.000kHz
500.00kHz
5.0000MHz
10.000MHz