R
ADIANT
S
TEAKHOUSE
B
ROILER
A
CCESS TO
S
ERVICEABLE
P
ARTS
Some serviceable parts are only accessible by removing body side panels or the burner cover.
The burner cover is fastened with ten sheet-metal screws. To remove the burner cover, remove these screws. The
burner cover can then be pulled forward and removed. Each body side panel is fastened with seven sheet-metal
screws, three in the front and four at the rear. Remove body-side screws and slide the body side towards the rear
and away from the unit.
Figure 6
Access to Serviceable Parts
Burner Cover
Pilot Adjustment
Screw
Body Side Panel
Burner Venturi
A
DJUSTMENT OF
B
ROILER
P
ILOTS
The pilots are adjusted at the factory. If later the pilots are over-adjusted to the point where the flame is leaving its
port, or “blowing off,” the result is an unstable condition in which the pilot may extinguish. If necessary, adjust the
pilots using the following procedure:
1. If necessary, light the pilots.
2. Locate the pilot adjustment screw (which adjusts all pilots). It is a small slotted screw located on the pilot valve,
and can be adjusted though an access hole in the burner cover (shown in Figure 6 above).
3. Turn the pilot adjustment screw to adjust the size of the pilot flames. The flame on each pilot should be large
enough to extend along the flame carrier to the burner surface.
O
WNER
’
S
M
ANUAL
1190950
(02/09) P
AGE
17
OF
20
