Southbend 121C-0, Руководство пользователя

Страница: 7 / 69

INSTALLATION
WARNING:
FOR AN APPLIANCE EQUIPPED WITH CASTERS, THE INSTALLATION SHALL BE MADE
WITH A CONNECTOR THAT COMPLIES WITH THE STANDARD FOR CONNECTORS FOR
MOVABLE GAS APPLIANCES, ANSI Z21.69-1987, CAN1 6.10-88 AND A QUICK-DISCONNECT
DEVICE THAT COMPLIES WITH THE STANDARD FOR QUICK-DISCONNECT DEVICES FOR
USE WITH GAS FUEL, ANSI Z21.41-1978, AND ADDENDA, Z21.41a-1981, Z21.41b.l983 AND
CAN1 6.9 M79. ADEQUATE MEANS MUST BE PROVIDED TO LIMIT THE MOVEMENT OF
THE APPLIANCE WITHOUT DEPENDING ON THE CONNECTOR AND THE QUICK-
DISCONNECT DEVICE OR ITS ASSOCIATED PIPING TO LIMIT THE APPLIANCE
MOVEMENT.
WARNING:
IF DISCONNECTION OF THIS RESTRAINT IS NECESSARY TO REMOVE THE APPLIANCE
FOR CLEANING, ETC., RECONNECT IT WHEN THE APPLIANCE IS MOVED TO ITS
ORIGINALLY INSTALLED POSITION.
GAS CONNECTION:
On all threaded connections the pipe joint compound must be approved for used with natural and LP gas.
I. INDIVIDUAL UNITS:
1. Remove valve panel.
2. Use a long spirit level four ways; across the front top rail and rear collar plate, and along each edge.
3. A. For units without a rear gas connections connect the gas supply to the right or left side of the manifold. Be sure
to cap the unused side
B. For units with a rear gas connection the gas supply to the unit will be made at the right rear. Be certain both
ends of the manifold are capped.
4. Turn off all burner valves.
5. Turn on gas supply and immediately check all gas connections for leaks. Use soapy water only. Never use an open
flame.
6. Put valve panel back onto the unit.
7. Proceed to "MOUNTING SHELF OR BACKSPLASH INSTALLATION INSTRUCTIONS," if applicable.
SECTIONAL RANGES
SECTION ONE — INSTALLATION
PAGE 5