South-Tek Systems 70CPH, Руководство по эксплуатации и установке

Страница: 17 / 22

BrewBlast™ 70CPH O&M
South-Tek Systems
17
6 SYSTEM MAINTENANCE
When performing maintenance
on the BrewBlast™ BrewBlast™ 70CPH, make sure to power down the system.
Remove the front cover to gain access to the filters.
Annual Filter replacement kit part # FRP-001
Air Pre-Filter
The integrated Air Compressor has an air intake pre-filter. It is designed to prevent particles from entering into the
compressor housing and damaging internal components. This filter needs to be replaced once per year or every
1,000 hours, whichever comes first. To do so, remove the pre-compressor filter cap by twisting it clockwise.
Remove the old element and use a clean dry cloth to clean the filter bowl before installing the new element.
Particulate and Coalescing Filter
The particulate and coalescing filter after the air compressor is designed to capture particulate and moisture prior to
entering the rest of the system. These filters and seals need to be replaced once per year or every 1,000 hours,
whichever comes first. To do so,
WARNING: Do not try to remove filter bowls until the filter is completely depressurized.
1. Disconnect the clear-blue drain tubes from the bottom of the bowls.
2. To remove the bowl, turn the metal casing around the blue plastic filter bowl counter-clockwise until it
unscrews completely from the filter housing. Then twist slightly and pull the blue plastic bowl downwards
out of the housing.
3. Inspect the bowls. If the drain system is working properly, the bowls should not be full of water.
4. Remove the particulate filter element by pulling the black plastic filter element holder out of the filter bowl
and, carefully, twisting the top and bottom piece counter-clockwise until the holder pulls apart. Take notice
of how the element looks. If the element is excessively dirty, more frequent filter changes are
recommended.
5. The coalescing element can be removed by turning it counter-clockwise by hand; then replace with the new
element in the reverse order.
NOTE: A plugged drain system will cause water and oil to carry over into the system, which will cause permanent
damage to the media inside the unit. Such damage is not covered by the manufacturer's warranty. Use of filters
other than those specified by South-Tek Systems could result in damages not covered by the warranty.