South Bend Tools SB1122, Руководство пользователя

Страница: 22 / 88

-20-
For Machines Mfd. Since 10/21
South Bend Tools
Model SB1122
P R E P A R A T I O N
15. Press manual ON button
I
(see Figure 20)
to start blade. Verify cutting fluid flows
through blade guides and onto blade and
that blade brush spins. Machine should run
smoothly and without unusual problems and
noises.
14. Open (2) cutting fluid valves (see Figure 19).
Figure Figure 19. . Cutting fluid valve opened. Cutting fluid valve opened.
Cutting Fluid Valve Cutting Fluid Valve
(1 of 2) (1 of 2)
Figure Figure 20. . Control panel. Control panel.
Vise Switch Vise Switch
Manual ON Manual ON
Button Button
Blade Speed Dial Blade Speed Dial
Manual OFF Manual OFF
Button Button
— If machine does not run smoothly,
disconnect machine from power and refer
to Troubleshooting on Page 61 before
proceeding with Test Run.
16. Slowly turn blade speed dial clockwise
(see Figure 20). Watch blade and rotate
dial back and forth to test variable-speed
function.
AUTO CUTTING AUTO CUTTING
Button Button
Figure Figure 21. . Location of AUTO CUTTING button. Location of AUTO CUTTING button.
17. Press manual OFF button
O
(see
Figure 20). Cutting fluid pump and blade
should stop.
18. Turn man/auto key switch /
counterclockwise to switch to automatic
operation mode.
19. Adjust blade speed dial to between 98–177
FPM.
Note: This is correct break-in blade speed
range for carbon steel and pre-installed
blade.
20. Turn downfeed rate dial all the way
clockwise, then
1
⁄
2
" counterclockwise.
21. Turn vise switch (see Figure 20) to OPEN
position so vise will open after cut is
complete.
22. Press AUTO CUTTING button (see
Figure 21). Automatic cut cycle should
begin: vise will close, cutting fluid pump
and blade will start, headstock will lower
and bandsaw will perform cut. Once cut is
complete, blade will stop, headstock will
raise out of workpiece, and vise will open.
IMPORTANT: Headstock will lower quickly
until blade contacts workpiece, then it will
slow to downfeed rate setting.