South Bend Tools Oil Country Series, Руководство пользователя

Страница: 54 / 68

South Bend Tools South Bend Tools
-52-
For Machines Mfd. Since 7/19 Model SB1065F–SB1071F
S E R V I C E
The carriage uses flat non tapered gibs. The
carriage saddle has "V-grooves" that sit on top
of v-shaped bedways. T he underside of these
bedways are flat where the "flat gibs" rub
against.
Tools Needed Qty
Hex Wrench 5mm .................................................1
Wrench 13mm .......................................................1
The se gibs are considered to be correctly adjusted
when the saddle rear gib screws (see Figure 80)
are slightly pre-loading the gibs ag ainst the flat
side of the way. Adjustment is made by loosening
the jam nuts and tightening set screws to the
desired preload.
Note
: Depending on the accessories ordered with
your lathe, access to gib screws may require
removal of those accessories.
Figure 80. Rear saddle gib screws. Figure 80. Rear saddle gib screws.
Saddle Rear Gib Screws Saddle Rear Gib Screws
Carriage Tailstock
The tailstock offset gib will rarely ever need to be
adjusted, but if it does, follow these steps.
Tools Needed Qty
Standard Flat Screwdriver #3 ..............................1
Wrench 32mm .......................................................1
Hex Wrench 10mm ...............................................1
Hex Wrench 8mm .................................................1
1.
Using a 32mm wrench; loosen both clamp
nuts under tailstock upper casting (see
Figure 79) to release clamping pressure
between tailstock and lathe bed.
Figure 79. Tailstock gib adjustment. Figure 79. Tailstock gib adjustment.
Gib Adjustment Gib Adjustment
Screw (1 of 2) Screw (1 of 2)
Clamping Cap Clamping Cap
Screw Screw
Offset Adjustment Offset Adjustment
Screw (1 of 2) Screw (1 of 2)
2.
Loosen both clamping cap screws at either
end of tailstock (see Figure 79) to release
clamping pressure between two tailstock
halves.
3. Using an 8mm hex wrench, test gib
adjustment by using offset adjustment cap
screws.
4. Use a flat head screwdriver to adjust gib in
or out.
5.
When you are satisfied with setting,
retighten clamping hex bolts.
Clamp Nut Clamp Nut
(1 of 2) (1 of 2)