Sourcetronic MPK-2000e, Руководство пользователя

Страница: 9 / 16

11
6. Turning the test current control

clockwise increases the current.
Adjust this control until obtaining the desired value or until the current
indicator (bargraph) indicates 100%. The bargraph will show the test
current value as a percentage of the nominal value selected by using
the test current selector

.
7. The lowest current for measuring is 10% of the nominal value. It is
important to consider that the measurement errors increase while test
current decreases. The equipment accuracy is specified for test
currents higher than 80%.
8. The display

will show the resistance value measured and the
corresponding unit ( Ω [ohms], m Ω [milli-ohms] or µ Ω [micro-ohms]).
9. The value can be retained in the display by pressing the hold

key.
Pressing this key again, the value will be released.
10. Press the Stop

key in order to finish the measurement. Do not turn
Off the equipment without pressing the Stop

key before.
11. Finally, when finishing measurements, turn the equipment Off using
the On/Off

switch.
Precaution: Do not connect or disconnect the test leads during the
measurement.