SA262
Ventris Dual Reverb Owner’s Manual
28
CONTROL INPUT button then switch the Toggle Switch back to A+B (To switch back to Parallel
Mode, repeat the process without holding down the CONTROL INPUT button). When
combining the reverbs in Cascade Mode, CONTROL 1 sets the wet/dry mix of Reverb A,
CONTROL 2 sets the wet/dry mix of Reverb B, and MIX sets the level of the dry signal. The
figure below illustrates the Cascade/A+B signal path and altered knob functions.
Follow the instructions below to create dual reverb presets:
1.
Select the preset you would like to edit by clicking the SELECT/(HOLD)
SAVE
Button until the
corresponding P
RESET
LED is lit.
2.
Select Reverb A with the A/B Reverb Toggle Switch and dial in your settings with the front panel
controls or Neuro Editor.
3.
Flip the A/B Reverb Toggle Switch to Reverb B and dial in the settings for Reverb B. Please note
that it is possible to use different reverb engines in Reverbs A and B.
4.
Flip the A/B Reverb Toggle Switch to A+B. By default the A+B reverb is routed in parallel, if you
wish to run your Reverbs in series (Note: Reverb A always cascades into Reverb B), flip back to
Reverb A, press and hold the CONTROL INPUT button at the top of the pedal, and switch the
toggle back to A+B. The A and B Reverbs will now run in series. To switch back to Parallel Mode,
repeat the process without holding down the CONTROL INPUT button.
5.
In A+B Mode the functions of the CONTROL 1, CONTROL 2, and MIX knobs change. When
running the reverbs in Parallel, CONTROL 1 sets the wet level of Reverb A, CONTROL 2 sets the
wet level of Reverb B, and MIX sets the level of the dry signal. When routing the reverbs in
Cascade Mode, CONTROL 1 sets the wet/dry mix of Reverb A, CONTROL 2 sets the wet/dry mix
of Reverb B, and MIX sets the level of the dry signal. In A+B Mode, the TIME, PRE-DELAY and
TREBLE knobs will override the knob positions selected in steps 2 and 3.
6.
Select the A/B Reverb Toggle Switch position to which you would like the Preset to initially
engage (A, B, or A+B).
7.
Press and hold the SELECT/(HOLD)
SAVE
Button. Continue holding the SELECT/(HOLD)
SAVE
until
the P
RESET
LED blinks fast, then slow, and eventually turns solid. This indicates that the preset
has been saved. To copy a preset from one location to another, see the
Copying a Preset
section below.
8.
Note
: It is also possible to route A+B Reverb Presets so that Reverb A routes exclusively to
Output 1 and only Reverb B routes exclusively to Output 2
–
thi
s is called “Independent Stereo
Mode
”
and it is one of the alternate routing options available via the Neuro Editor. Go to the
Neuro Sound Editor
section for more info on Independent Stereo modes.
1
Reverb
B
Reverb
A
1
Analog Dry Path
Digital Dry Path
Digital Dry Path
Reverb A Mix
CONTROL 1
Analog Dry Level
Reverb B Mix
CONTROL 2
MIX
Dual Cascade Knob Controls (toggle = A+B)