NOTE: This connection procedure is only for receivers that have
connections. If the receiver does not have these
connections, use
Method A- 1 Amplifier Wiring Hook-up Steps For Most Receivers located on page 5.
1. IMPORTANT: Make sure that ALL stereo system components including the THP-CXB are turned OFF before proceeding.
2. Locate the
MAIN
on the back of the receiver.
3. Remove the small metal
U’s that are plugged into the PRE
connections on the back of the receiver.
4. Connect a pair of high-quality line-level connection cables RCA patch cords between the receivers PRE
connections
and the LINE IN connections on the back of the
THP-CXB. Make sure that left is connected to left and right is connected to
right. We recommend that you treat the RED connection cable RCA plug as RIGHT and the BLACK or GREY plug as LEFT.
5. Connect another set of connection cables between the THP-CXB LINE OUT connections and the MAIN INPUTS of the
receiver. Again, make sure that left is connected to left and right is connected to right.
6. Connect the main left and right speakers to the speaker terminals on the back of the receiver.
7. Connect the Soundolier or other subwoofer to the round red and black “TO SUBWOOFER” terminals on the back of the
CXB. Make sure that polarity is
correct, using the BLACK binding
post for the ( ) connection and the
RED binding post for the ( + )
connection.
8. IMPORTANT: Consult the owner’s
manual that came with the
subwoofer to determine if it is rated
at 4 ohms or 8 ohms. Then set the
“4 OHM 8 OHM”
switch accordingly. If you are using
two subwoofers, refer to the section
titled; “Using Two Subwoofers” on
page 4.
NOTE: See Section C:
REAR PANEL TOUR, “4 OHM
8 OHM switch”, for additional infor-
mation on page 3.
9. You are now ready to put the
and subwoofer to use. Skip to
the next section, titled:
CXB Front Panel Mini Tour
o n
page 10.
Line Level
up
with Receiver
that has
Connections
7
