SoundMax SM-DVR78FHD, Инструкция по эксплуатации

Страница: 4 / 20

3
Instruction manual
Rear panel
Operations
Power and charging
To charge the battery of this unit use a
miniUSB-USB cable (not included); or
connect it to a car lighter socket with the
supplied car adapter. The power icon
on the display indicates the remaining
battery power.
Video mode
•
Before you start recording, insert a MicroSD
memory card into the memory card slot of this
unit until a click. Insert the card with correct
side. Start the car engine, the recorder will
power on automatically.
MicroSD capacity supported: up to
64 GB, class 10 or higher. For correct and
satisfactory operation, licensed MicroSD
memory cards of well-known brands should be
used with this unit. Avoid using memory cards
of unknown brands.
•
Auto recording: After you connect
the unit to the car power source and start the
engine, the recording will be started
automatically. After you disconnect the
power source, the unit will automatically shut
down in 5 seconds.
•
Manual recording: Press and hold
the POWER button to switch on the unit
(press and hold it again if you want to switch
off ). Press OK button to start recording.
Press this button again to stop recording.
•
While recording, the recording time is
shown in red figures in the top right corner of
the display. The unit will save video files
automatically after each 1/2/3 minutes (see
the "Setup" paragraph below for more
details). When the memory card is full, old
files will be deleted and the new files will be
recorded instead. Press OK button to stop
and to continue recording.
12. RESET button (hole)
13. Microphone
14. Speaker
15. Camera lens
Mounting
• Clean the car rearview mirror with a cloth.
•
•
Tear off the adhesive protective tape on the
recorder.
Attach the recorder on top the car rearview
mirror so as not to block the camera lens
and secure with rubber straps.
•
Connect the USB terminal of the car charger
to the mini USB socket of the recorder.
• Adjust the horizontal and vertical position of
the camera.
• Install the rearview camera in the rear of the
vehicle and pay attention to the direction when
installing. Connect the camera to the AV-IN
interface of the recorder. Wiring can be laid
along the roof of the vehicle.
12 13 14
15