Page 6
5
4
3
2
1
0
1
2
3
4
5
10
9
8
7
6
5
4
3
2
1
0
4
5
7
14
12
8
19
13
11
1
2
3
10
9
6
18
16
15
17
9
The yellow LIMIT LED lights when the Limiter is active.
10
The balanced TAPE SEND jack is fed from the output of the
Limiter.
11
The output level of the Tape Send may be switched between a
n4dBu to match professional tape machines, or a nomi-
nal -10dBV to suit semi-professional equipment. The position of
this switch simultaneously changes the input level of the Tape
Return.
MONITOR PATH
12
The electronically balanced Tape Return is the input to the Monitor
path, and has switchable input level as set by the -10dBV/+4dBu
switch.
13
An Insert Point is provided for the connection of external process-
ing equipment. The Send is unbalanced, and the the Return is
balanced. The Insert is normally in the Monitor path, but may be
switched to the Channel path if required (see 14 below).
The Insert Send and Return are on separate jacks which are nor-
malled together, but the non-breaking Send allows a separate
feed to be taken from the channel path, for instance to feed a PA
desk.
14
The Insert is normally in the Monitor path, but may be swapped to
the Channel path if required by pressing this switch.
15
A single Auxiliary Send is provided, normally in the Monitor path
(but see 16 below) which may be used to set up a separate mix
for Foldback or Effects. The combination of all the Aux Sends is
mixed to the Aux output at the rear of the unit. The Send may be
globally switched as pre-fade (ideal for foldback applications) or
post-fade (ideal for effects, so that the send follows the fader posi-
tion). Leave the knob turned fully anticlockwise when not in use.
16
The Aux Send is normally in the Monitor path, but may be
swapped to the Channel path if required by pressing this switch.
When switched to the Channel path the Send is always effectively
pre-fade.
17
The Fader sets the overall level of the Monitor signal path. Unity
gain is at the 0 position, with 10dB gain in hand.
18
The PAN control sets the amount of the Monitor signal feeding the
stereo Mix output, allowing you to move the signal smoothly
across the stereo image. Rotation fully anticlockwise feeds the sig-
nal solely to the Left mix buss, while rotation clockwise sweeps the
image to the Right.
19
When the PFL switch is pressed, the pre-fade signal is fed to the
Monitor/Phones outputs, where it replaces the selected source.
The meters follow the monitor source to display the PFL signal.
The SOLO LED lights to warn that the monitor and meters are now
responding to the PFL selection.
