SoundCraft SM 16, Руководство пользователя

Страница: 23 / 46

Stereo Mix
19
The post-fader signal is sent to the stereo mix bus via the L/R (level) and PAN
controls. The PAN control gives a 4.5dB centre drop. The mix bus send is activated
by the ON switch, which has an integral green LED, and may be set pre- or post-fade
by the PRE switch. The pre-fade signal may be sourced from one of the following
three options:
•
post-mute and pre-fade
•
pre-mute
•
pre-EQ and pre-insert
The source selection is done using push-on jumpers.
The factory default is post-mute and pre-fade.
Metering
20
The red PEAK LED illuminates when the signal level e14dBu
(internal) at the output of the input amp, the insert return, the output of the EQ or
the post-fader amplifier.
A 16-segment peak-reading bargraph meter in the overbridge meters the signal
directly after the input amplifier. The meter has a peak-reading ballistic
characteristic.
Jumper Options
(RH PCB)
Function Options Default
Insert point post-EQ
J1, J3, J6 jumpers IN for post-EQ
J2, J4, J5 jumpers IN for pre-EQ
Group 1-8 Pre-fade signal post-mute
J14 jumper IN for pre-EQ & pre-insert
J15 jumper IN for pre-mute
J13 jumper IN for post-mute & pre-fade
Note: only one of the above three jumpers to be fitted at any one time.
Group 9-16 Pre-fade signal post-mute
J11 jumper IN for pre-EQ & pre-insert
J10 jumper IN for pre-mute
J12 jumper IN for post-mute & pre-fade
Note: only one of the above three jumpers to be fitted at any one time.
Mix L-R Pre-fade signal post-mute
J8 jumper IN for pre-EQ & pre-insert
J9 jumper IN for pre-mute
J7 jumper IN for post-mute & pre-fade
Note: only one of the above three jumpers to be fitted at any one time.
Input Module 19