www.soundskulptor.com
Document revision 1.1 – Last modification : 01/05/14
EQ573 Assembly guide – Final assembly
30. Side panel
Attach the side panel to the front plate with two M3x6 black
countersunk screws.
31. Main PCB
Install the main PCB on the side panel, inserting the 2x40 pins header into the PCB holes. Attach it with
two M3x6 screws and two shake-proof washers in the front and two M3x20 male/female spacers in the
back.
32. Header soldering
Solder the header's 2x40 pins that link the two PCB's, starting with the row that is close to the PCB
edge. Cut flush 4 or 5 pairs of pins near the centre of the header, where a spacer will be installed.
33. 25mm Spacers
Remove the front panel by unscrewing
three M3x6 black screws.
Attach three 25mm spacers to the
switches PCB, on the solder side, with
three M3x6 screws.
34. Potentiometer 6/4mm shaft adapters
On the potentiometers PCB, set all three pots
fully clockwise. Insert the three 6mm/4mm
adapters all the way down, with the screws
facing towards the PCB edge that carries the
two connectors. Tighten the screws.
35. Potentiometer 4/3mm shaft adapters
While keeping the pots in their full clockwise position, insert the three
4mm/3mm adapters with their slot perpendicular to the screw (facing up).
Tighten gently, just enough to hold them into position.
Copyright ©2011 to today SoundSkulptor
