USE AND MAINTENANCE MANUAL
MANUAL DOUGH SHEETER
Mod. SPT0/1-E - SPT3/1-E
Code
3529.0031.01
Revision A
date
06/09/2011
Arc. 86
Technical Assistance Service - Phone (+39) 0445.595.111
21
4.2 USE OF THE MACHINE
•
Rest the dough to be rolled in the middle of the right-hand conveyor surface. Using the rolling
pin provided, roll the dough in right-left and forward-back movements to reduce the thickness
until you obtain a thickness of approximately 40/50 mm.
•
Set the adjustment handle (11) to maximum opening.
•
Ensure that the movement control lever (7) is in the central “idle” position. Switch the master
switch (13) from position “0” to position “1”. Ensure that the emergency push-button (9) is
disengaged.
•
Turn the control lever (7) to the left; this will move the conveyor belt from right to left. As soon
as all the dough has moved beyond the cylinders, reset the control lever (7) to the central idle
position (*), thus stopping the machine. Reduce the rolling thickness by approximately 4/8 mm.
Turn the control lever (7) to the right, thus moving the conveyor belt from left to right. This
operation must be repeated until you obtain the required final thickness.
•
As soon as you finish the penultimate rolling operation, the machine must be set to wrap the
sheet obtained around the rolling pin. Set the control lever (7) to the idle position. Position the
rolling pin on the conveyor belt surface opposite the sheet between support and conveyor belt
(Figure –a2-). Set the adjustment handle (11) to the required final thickness. Via the control
lever (7) start the sheet moving again towards the rolling pin. As soon as the sheet reaches the
rolling pin, help it to wrap round the rolling pin half a turn; it will then continue on its own and
complete the wrapping operation by inertia.
•
During the rolling operation, the operator may need to lift one of the two protection grilles (10)
to inspect the product or for flour dusting. When the protection grilles are lifted, as described
previously in the point “protections” on p.12, the machine will stop. Once you have finished,
simply lower the grille and press the start button (8).
Figure –a2-
(*) The lever can be easily adjusted to different positions as it engages in a self-locating machined
groove, thus making intermediate settings impossible.
