USE AND MAINTENANCE MANUAL
MANUAL DOUGH SHEETER
Mod. SPT0/1-E - SPT3/1-E
Code
3529.0031.01
Revision A
date
06/09/2011
Arc. 86
Technical Assistance Service - Phone (+39) 0445.595.111
11
1.6 INSTRUCTIONS FOR INDOOR HANDLING
The dough sheeter mod.SPT0/1-E – SPT3/1-E is provided with three wheels, two rear wheels(*)
and one front wheel, and two stabiliser feet located at the side of the front wheel. The front wheel
is operated by a mechanical pedal located at the front of the machine just above floor level. The
stabiliser feet are designed to ensure correct machine stability with respect to the floor. The
machine must be positioned in its place of work using the wheels. As soon as you have found the
ideal work position, press the pedal: the machine will be lowered slightly and the two feet will rest
on the floor. To move the machine again, raise it four centimetres by means of the handle and
release the weight. The front wheel is now ready for operation.
If you need to clean the floor or other, the two side worktops can be raised. This operation must be
performed raising one worktop at a time. Once maximum lifting position has been reached, a
mechanical stop will cut in consisting of a pin in the worktop engaging in a slot in the protection
grid.
Once the machine is positionned on the other place, stabilise it through the pedal located on the
bottom of the basement.
!
CAUTION
Indoor handling must be performed by adopting all the precautions
necessary to prevent damage to the machine components.
(*) The front or rear position is defined with respect to an operator standing in front of the
calibration thickness adjustment handle.
1.7 DECOMMISSIONING
1.7.1 SETTING ASIDE
−
If the machine has to be stored, it must be protected against dust and stored in a covered
place.
−
If the machine is not going to be used for a long time, it must be protected against dust and
atmospheric agents by means of appropriate covering.
−
No special precautions are required for the motor and electrical system; simply follow the above
instructions.
1.7.2 SCRAPPING
−
To scrap the machine, proceed as follows:
1. Eliminate the electricity supply cable.
2. Remove all moving parts that could be a hazard.
3. Dispose of the majority of parts as scrap metal and take to authorised scrapyards.
4. The other parts, plastic for example, must be disposed of according to current
regulations, via specialist firms if necessary.
