© 1996-2021 SOTA Instruments Inc.
Page 9 of 12
|
www.sota.com
The Silver Pulser Model ZBB2 Manual
HOW TO USE THE IONIC~COLLOIDAL SILVER FUNCTION
HOW TO ASSEMBLE THE SILVER WIRE HOLDER OPTION
1.
The Silver Wires fit into the two small holes in the Silver
Wire Holder as in the picture.
2. To insert the Silver Wires, move the spring clip away from
the hole.
3. Push the wire through the hole. Most of the wire should be
below the holder. Release the spring clip to hold the Silver
Wire snuggly in place. It may be easier to insert from the
underside of the holder.
4. Repeat Step 2 for the second Silver Wire.
5. Plug the Silver Wire Holder into the Silver
Pulser.
HOW TO MAKE IONIC~COLLOIDAL SILVER
1. Insert Silver Wire Cord or Silver Wire
Holder into the unit.
2. Heat 2 cups (500 ml) of distilled water to the
boiling point—preferably in a non–metal
container. Do not use a glass measuring cup
on the stove top as it may explode.
3. Use a heat-resistant glass container to make
Ionic~Colloidal Silver.
SILVER CORD OPTION
4. Place the Silver Wires in the glass container
immersing at least 70% of the Silver Wires into the water.
Keep them at least 25 mm or 1 inch from the bottom of
the container and 1 inch between the wires. See image 1.
SILVER WIRE HOLDER OPTION
4. Place the Silver Wire Holder on the glass container
immersing at least 70% of the Silver Wires into the water.
Keep them at least 25 mm or 1 inch from the bottom of
the container. See image 2.
2
1
