Sorensen SFA Series, Руководство по эксплуатации

Страница: 31 / 58

Sorensen SFA Series Operation
Refer to Figure 3–2 and the corresponding descriptions below for an
explanation of rear panel connectors.
10
11 12 13 14 15
16 17
18
Figure 3–2. Rear Panel Connectors (3U model shown)
10 DC OUTPUT: Positive (+) and negative (–) outputs. Threaded studs for 5-15kW models; bus bars
for 20-30kW models.
11 ANALOG CONTROL Connector (J1): I/O connector for input programming and analog
output monitoring signals as well as status indication and remote shutdown signals.
See Table 3–1 for individual pin descriptions.
12 SENSE Connector (J3): Input connector for load voltage sensing to provide a more
accurate voltage measurement by compensating for line drops in the load cables (see
Section 3.4).
13 PARALLEL IN Connector: Allows master/slave configuration of up to five units when
connected to another unit’s PARALLEL OUT connector (see Section 3.8).
14
PARALLEL OUT Connector: Allows master/slave configuration of up to five units when connected
to another unit's PARALLEL IN connector (see Section 3.8).
15
RS232 Connector: Optional RJ-11 connector for remote control.
16 Dipswitch: Eight–position dipswitch to configure an SFA Series unit with an IEEE option.
17 GPIB Connector: Optional connector for remote control.
18 AC Input Bus Bars: Connection for 3-phase AC and Ground.
M550292-01 Rev C 3-3