EN 15
9.
Repairs of defective parts and electrical contacts should only be done by the
manufacturer before the device is used, in line with the instructions.
10.
Start to work at a low speed to avoid any overloading of the motor and any
unnecessary splashing of injection mortar.
11.
To avoid overpressure in the injection cartridges, always use a new mixing
nozzle after every interruption in your work or with cartridges that are only
partially empty. When working with a blocked mixing nozzle, the cartridges
can burst and cause damage.
12.
Please note the use-by date on the injection cartridge. Cartridges with an ex-
pired use-by date und dried-out cartridges can cause overload of and damage
to the device.
13.
Please note the information on the injection cartridge on use and processing
temperature and comply with this conscientiously. That will avoid overloa-
ding of the device.
14.
A soft cloth with soapy water is sufficient for cleaning. The following agents
may not be used for cleaning the device: petrol, paint thinner, tetrachloride,
alcohol, ammonia, chloric acids and oils. This could result in defects.
15.
Do not store the machine and battery pack in locations where the tempera-
ture may reach or 50°C (122°F).
Safety instructions for the charger and battery pack
WARNING!
1.
Please only use original batteries. Other battery packs can burn out and injure
people.
2.
Before you connect the charger, please read the instructions for use carefully.
3.
Do not expose charger to rain, snow or other kind of moisture.
4.
To maintain the perfect functioning of the charging cable, hold the cable by
the plug when you pull it out of the socket.
5.
If the safety instructions are not complied with, there is a risk of fire and/or
injury from electric shocks.
6.
Ensure that there is no risk of other people falling over the cable or charger.
7.
If the cable or plug of the charger are faulty, they must be replaced immedia-
tely. The charger may not be connected to the mains in that case.
8.
Do not use the charger if it is damaged by overload, knocks or other mecha-
nical effects. Do not open the device yourself; instead, have it checked by the
manufacturer.
9.
Keep the charger clean. Disconnect the device from the mains before
cleaning. The charger and battery pack may not be opened.
10.
Do not attempt to use a set-up transformer, an engine generator or DC power
receptacle.
11.
Do not allow anything to cover or clog the charger vents.
12.
Always cover the battery pack terminals with the battery pack cover when
the battery pack is not used.
Содержание 344027
Страница 101: ...Pachetele de baterii defecte trebuie reciclate în conformitate cu Directiva 91 157 EEC Recycle ...
Страница 108: ......
