Sophos XGS 5500, Руководство по эксплуатации

Страница: 12 / 15

12 XGS 5500/6500
Operating Instructions
Important note: Please check the technical specs above for the min. and max. rack depth.
2. Choose the rack location:
Ì Leave enough clearance in front of the rack so that you can
open the front door completely (~60 cm/25 inches).
Ì
Leave approximately 80 cm/30 inches of clearance in the back of
the rack to allow for sufficient airflow and ease in servicing.
Ì This product is for installation only in a restricted access location
(dedicated equipment rooms, service closets and the like).
3. Install the sliding rails:
Ì Please refer to the dedicated Sliding Rails Mounting
Instructions shipped with the appliance.
Connection and Configuration
How to connect the appliance is described in the Hardware Quick Start Guide. For
configuration you can follow the initial setup wizard described in the WebAdmin Quick Start
Guide or cancel it and perform a manual setup (see the
Sophos Firewall How-To Library ).
RAID (SSD) System
The XGS 5500/6500 models are equipped with a RAID-1 system with two Solid State
Drive. A RAID system (redundant array of independent disks) connects several physical
Solid State Drive to one particularly performing logical drive. RAID-1 enhances the data
security and consistency of your system by mirroring all data of the first SSD to the second
redundant SSD. In case one of the SSDs fail your system will still be fully operational.
However since it no longer provides SSD redundancy you should contact your local Sophos
partner to get the faulty SSD replaced as soon as possible.
Power Supply Cord Retention
Each power supply module is equipped with a plastic cord retention device.
The as-shipped state has the cord retention ring close to the power supply connector. This
will need to be moved away from the power supply in order to plug in the cord. This can be
accomplished by pulling the release tab away from the ring and sliding it along the cord
ring guide.
If the cord retention device is to be used, plug the cord into the supply and place the cord in
the retention ring and snap the ring shut, but not tight.
Slide the ring along the cord ring guide toward the power supply until it touches the cord
connector.