Sony XTL-W7000, Инструкция по установке/подключению

Страница: 16 / 48

16
Notes
• The molding on the front pillar will be
fastened in place with clips or screws.
When removing it, take care not to
damage or deform it.
• When performing the installation
yourself, if you decide it is too difficult
to remove the front pillar molding,
please contact your dealer for
assistance. (Note that your dealer may
charge a fee for their assistance.)
Film antenna mounting procedure
1
Check the film antenna
qf
mounting position.
1 Align the film antenna power supply point with the lower
edge of the window’s ceramic line and fasten temporarily
in place with cellophane tape.
Do not remove the adhesive backing from the antenna yet.
The figure below shows the results of this step, for the left
antenna. Temporarily position the right antenna in the
same manner.
2 Mark the left and right sides of the film antenna, using
cellophane tape, etc.
2
Remove the inner molding from the front pillars on
both sides of the front window.
(The above figure shows an example of a car, such as a sedan
or SUV, which as a handle mounted on the front pillar.)
About 120 mm
Power supply point
Ceramic line
Align the
upper edge of
the antenna
with this line.
Temporary fastener
(cellophane tape, etc.)
marking (cellophane tape, etc.)
Front pillar