11
EN
Additional Information
Troubleshooting guide
The following checklist will assist in the correction of most problems you may encounter with your
unit.
Before going through the checklist below, refer to the operating procedures.
General
Cause/Solution
•
Adjust the volume with
(+)
.
•
Set the fader control to the center position for 2-speaker
systems.
•
An optional power amplifier is connected and you are not
using the built-in amplifier.
•
The beep tone is muted.
Tape playback
Cause/Solution
Contamination of the tape head.
n
Clean the head.
•
There is noise in the space between tracks.
•
A blank space is too short (less than four seconds).
•
+
on
(SEEK/AMS)
is pressed immediately before the
following track.
•
=
on
(SEEK/AMS)
is pressed immediately after the track
starts.
•
A long pause, or a passage of low frequencies or very low
sound level is treated as a blank space.
Radio reception
Cause/Solution
•
Store the correct frequency.
•
The broadcast is too weak.
The broadcast is too weak.
n
Use manual tuning.
Problem
No sound.
No beep tone.
Problem
Playback sound is distorted.
The AMS does not operate
correctly.
Problem
Preset tuning is not possible.
Automatic tuning is not possible.
