Sony XDCAM PDW-1500, Руководство по эксплуатации

Страница: 80 / 154

Chapt
er
6
I
n
s
e
rt E
d
it
ing
80
6-1 Clip Audio Insert Editing
Settings required for editing
The following table shows the settings required for editing.
6-1-2 Editing Operations
Setting edit points
Refer to the documentation of your editor for more
information about how to set edit points.
Note
When the In and Out point are not set in the same clip,
insert editing is performed only for the clip containing the
In point.
Executing audio mixing
You can mix input audio signals with this unit only,
without connecting an audio mixer.
The following example shows how to mix an external
audio input signal into the audio of channel 1 recorded on
the loaded disc.
1
Input the audio mix signal to channel 1.
Number of audio
recording channels and
number of quantizing bits Check the number of audio channels recorded in the clip and the number of quantizing bits with the
AUDIO indicators
(see page 25)
, and set the audio format to the same number of recording
channels and quantizing bits with the maintenance menu item “AUDIO CONFIG - “DATA LENGTH”
(see page 124)
.
See 8-4-2 “Maintenance Menu Operations” (page 126) for more information about how to make this
setting.
Audio/Non-audio (data) To perform insert editing of non-audio (data), set maintenance menu “AUDIO CONFIG” - “NON-
AUDIO INPUT”
(see page 124)
to “data.”
See 8-4-2 “Maintenance Menu Operations” (page 126) for more information about how to make this
setting.
Note
• When you insert non-audio into a clip, the channels containing the non-audio are treated as non-
audio across their entire length.
• Use channel pairs (CH1/2, CH3/4, CH5/6, CH7/8) for non-audio insert editing. Non-audio editing
is not executed unless a channel pair is specified.
Item Setting
Item Setting
Audio input signal Select the audio input signal with the AUDIO INPUT CH button
(see page 22)
and the AUDIO
INPUT SEL button
(see page 22)
.
Input audio level Adjust the input audio level with the ALL/CH-1 and CH-2 to CH-4 knobs
(see page 23)
.
Edit point transition type With extended menu item 317 “AUDIO EDIT MODE”
(see page 111)
, select “cut” (cut edit) or “cross”
(cross-fade).
See 8-3-2 “Extended Menu Operations” (page 120) for more information about how to make this
setting.
Audio Mix To perform audio mixing, use extended menu item 819 “AUDIO INPUT SOURCE ARRANGE”
(see
page 119)
to set the desired input channels to “on.”
See 8-3-2 “Extended Menu Operations” (page 120) for more information about how to make this
setting.
Clip 1
Clip 2
IN point
OUT point
Edit execution segment