Sony VPLGT100, Руководство по эксплуатации

Страница: 59 / 86

59
Ot
h
e
rs
3D video images
Others
Symptom Cause and Remedy
The video image does not
seem like 3D video images. c Check if the 3D glasses are turned on ( 1 page 23).
c Make sure that the battery in the 3D glasses is charged.
c Check if the input source is HDMI.
c Set “2D-3D Display Sel.” to “Auto” or “3D” ( 1 page 42).
c Check if the input signals are compatible 3D signals ( 1 page
72).
c
If no 3D signal is input from the 3D equipment connected to the
unit, restarting the connected 3D equipment may solve the
problem.
c
When the viewing or projector position is too far from the
screen, the 3D glasses may not be able to display the images
properly (
1
page 24).
c
If you use the optional 3D Sync Transmitter, check that it is
placed within the specified range (
1
page 18).
c
The screen size is not appropriate. Set the zooming
magnification to low or watch the image from farther away from
the screen (
1
page 78).
Symptom Cause and Remedy
The fan is noisy. c Check the setting of “High Altitude Mode” on the Setup
menu ( 1 page 40).
c Make sure that the room temperature is not too high.
c Check the installation conditions ( 1 page 8).
The number of fan rotation increases to maintain the product
reliability of the projector’s components in a room, where the
temperature is higher than normal. The fan noise becomes
slightly louder. The approximate normal temperature is 25°C.
The lens shift cannot be
adjusted.
c
The lens shift cannot be adjusted over the range of movement.
Adjust the lens shift within the range of movement (
1
pages 14, 77).
The unit and connected
equipment turn On/Off,
play back, and operate at
the same time.
c
“Control for HDMI,” “Device Auto Power Off,” and “PJ Auto
Power ON” are set to “On.” Set them to “Off.”
For details, see “HDMI Setting” (
1
page 43).