15
(EN)
3
Replace the lid.
Notes on batteries
• Be careful that the battery orientation is correct when
inserting batteries.
• Do not mix old battery with new one, or different
types of batteries.
• If you do not intend to use the Remote Commander
for a long time, remove the batteries to avoid damage
from battery leakage. If a battery has leaked, remove
the batteries, wipe the battery compartment dry and
replace the batteries with new ones.
Notes on wireless Remote Commander
operation
• Be sure that there is nothing to obstruct the infrared
beam between the Remote Commander and the
projector.
• The operation range is limited. The shorter the
distance between the Remote Commander and the
projector, the wider the angle within which the
commander can control the projector.
Battery installation
1
Push and slide to open the lid.
2
Install the two size AA (R6) batteries (supplied)
with the correct polarity.
• The remote control detectors on the projector do not
operate when connecting the remote commander
cable to the CONTROL S IN jack. If you wish to use
the Remote Commander as a wireless Remote
Commander, be sure to remove the remote
commander cable from both the Remote Commander
and the projector.
To connect the Remote Commander to the
projector
Note on wired Remote Commander operation
using the supplied stereo remote commander
cable
If the MOUSE/MENU switch is set to MENU to
operate the projector, you do not need to install the
batteries since the power is supplied from the
CONTROL S IN jack on the projector. In this case, the
batteries are not consumed.
Be sure to install
the battery from
the
’
side.
CONTROL S
OUT
IN
PLUG IN
POWER
REMOTE
RS-422A
0
INDEX
TRIG
0
S VIDEO
AUDIO OUT
VIDEO
R/R-Y
AUDIO IN
INPUT A
G/Y
B/B-Y SYNC/HD
Y IN
C IN
IN
OUT
IN
OUT
VD
AUDIO IN
REMOTE 1
IN
OUT
MODE
L
(MONO)
(MONO)
R
L
R
L
R
Stereo remote
commander cable
(supplied)
Remote Commander
to CONTROL S IN
to CONTROL
S OUT
Rear
