Your new hard disk drive is supplied with the necessary screws. Do not overtighten these screws when securing
the drive to the drive holder.
9.
Align the drive holder with the tracks on the inside of the chassis. Slide the drive holder in completely.
10.
Push the drive holder handle down to lock the drive into position.
11.
Connect the second drive connector to the new drive. Orient the connector to align pin 1 on the red side of the
ribbon cable with pin 1 on the new drive.
12.
Connect the second power connector to the new drive following the instructions supplied with the drive.
Replacing the driv e holder
13.
Replace the side panel. See
About Closing the Computer
.
14.
Reconnect the power cord to your computer.
Page 187
Содержание VGC-RA718G
Страница 11: ...Page 11 ...
Страница 59: ...Logs off from this computer or enables you to switch users Page 59 ...
Страница 155: ...Page 155 ...
Страница 174: ...4 Lift the side panel away from the unit and set aside Page 174 ...