Troubleshooting
67
Bluetooth Function
Battery Charger
Symptom
Possible causes/solution
Data cannot be
transmitted.
• The distance between the device and the
printer is too great.
t
Locate the devices within the
maximum communicable distance.
• The Bluetooth antenna portion of the
printer and/or the camera is covered with
a hand, etc.
t
Do not cover the antenna portion.
• The device you wish to connect with the
printer has been already connected with
another device.
t
Reconnect the device with the printer
after the device’s task with another
device is finished.
• Authentication failed.
t
Reconnect the printer with the device,
and enter the same passkey correctly
on both devices.
• The connected device interrupted the
transmission.
t
Check the status of the connected
device, then reconnect.
• The Bluetooth connection is interrupted
on the side of the connected device.
t
Check the status of the connected
device.
The connection is
disconnected.
• The same passkey is not entered.
t
Enter the same passkey correctly both
on the printer and the camera.
• The device disconnected or ended the
connection.
t
Check the status of the device, try to
connect to the device again, and enter
the passkey correctly.
Authentication
failed.
• The same passkey is not entered.
t
Enter the same passkey correctly both
on the printer and the camera.
• The device disconnected or ended the
connection.
t
Check the status of the device, try to
connect to the device again, and enter
the passkey correctly.
Data transmission
speed is too low.
• The Bluetooth antenna portion of the
printer and/or the camera is covered with
a hand, etc.
t
Do not cover the antenna portion.
Data transmission speed varies
depending on the distance between
the printer and the camera, obstacles,
or radio wave conditions. Change the
position of the printer or set the
printer closer to the device.
Even with the
distance between
the printer and the
desired device
within 10 m (33
feet), connection
cannot be
established.
• The Bluetooth antenna portion of the
printer and/or the camera is covered with
a hand, etc.
t
Do not cover the antenna portion.
Data transmission speed varies
depending on the distance between
the printer and the camera, obstacles,
or radio wave conditions.
Change the position of the printer or
set the printer closer to the device.
• The desired device is now connecting to
another device.
t
When the device is connected to
another device, the device may not be
displayed as an available device or be
connectable at that time.
• The device is not connectable with the
Bluetooth functions.
t
Set the device so that it is
connectable.
Symptom
Possible causes/solution
The CHARGE
lamp is flashing.
• Battery life ends or some trouble occurs
on the batteries.
t
Use new NH batteries.
• Batteries other then NH batteries are
being charged.
t
Replace them with the NH batteries.
The CHARGE
lamp does not
light.
• The batteries are installed incorrectly.
t
Install the batteries correctly.
• Imperfect contact of batteries
t
Clean the contacts of the battery
charger, and the
3
and
#
terminals
of the batteries.
• Imperfect contact with the power supply
t
Clean the plug.
t
Connect the battery charger to
another wall outlet.
Symptom
Possible causes/solution
Содержание UPX-C200
Страница 207: ......
Страница 208: ...Sony Corporation Printed in Japan ...