Sony UP-D898MD, Инструкция по эксплуатации

Страница: 10 / 31

Get
ting St
ar
te
d
Connections
10
G
COPY button (21)
Press to print another copy of the previous printout.
You can make only one copy each time you press
this button regardless of the print quantity set using
the menu.
H
OPEN button (13, 21)
Press to open the door panel. While a print job is in
progress, press to cancel the print job.
I
Paper cutter
Cuts the paper as each image is printed.
Rear Panel
A
USB connector (11)
Connects to a computer equipped with the USB
interface, using a USB cable compatible with Hi-
Speed USB (sold separately).
B
Equipotential ground terminal connector
Used to connect to the equipotential plug to bring
the various parts of a system to the same potential.
Refer to “Important safeguards/notices for use in
the medical environments” (page 3).
C
-
AC IN connector
Use a specified power cord.
Refer to “Warning on power connection” (page 6)
and “Warning on power connection for medical
use” (page 6).
Connections
After connecting the USB cable (sold separately) to the
unit and the computer, connect the power cord. For
details about the unit connection, refer to the manuals
for the computer or other peripheral devices.
Using this unit for medical purposes
This equipment's connectors are not isolated.
Do not connect any device other than one which
conforms to IEC60601-1.
When an information technology device or AV device
that uses an alternating current is connected, current
leakage may result in an electric shock to the patient or
operator.
If use of such a device is unavoidable, isolate its power
supply by connecting an isolation transformer, or by
connecting an isolator between the connecting cables.
After implementing these measures, confirm that the
reduced risk now conforms to IEC60601-1.
Notes
• Before connecting the unit to the computer, turn off
the unit, computer, monitor, and all peripheral devices
connected to the computer.
• Before connecting the unit to the computer, disconnect
the power cord from the unit. Connect the power cord
to the unit only after connecting the unit and the
computer.
• Follow the connection procedures described in the
computer manual.
• Make sure that the cables are connected securely at
both ends.
• The unit drive software provided with the unit is not
suitable for using the unit connected to a network.
• Printer operation is not guaranteed when connecting
to the computer using the USB cable via a hub.
• Two or more units cannot be connected to a single
computer.
Warning