Sony UP-D2600, Руководство по обслуживанию

Страница: 19 / 132

1-13
UP-D2600/V1(E)
24
Others
Troubleshooting
The following troubleshooting check will help you correct the most common
problems you may encounter with your unit. Before proceeding with these trouble
checks, first check that the power cord is firmly connected. Should the problem
persist, unplug the unit and contact your sony service facility or your Sony dealer.
Symptom
The printer does not print even
if the command is sent from the
computer.
The printer does not print.
Possible causes and remedies
• The POWER switch of the printer is not set to ON.
n Set the POWER switch of the printer to ON.
• Connection may not be correct.
n Check connections and rectify, if necessary.
• SCSI ID setting is not set correctly.
n Check the SCSI ID setting. (page 12)
The problem is indicated by the indicators on the front panel.
n See “Indicators on the Front Panel” on page 25 and perform
the proper remedies.
25
Others
Indicators on the Front Panel
If a problem occurs, the indicators on the front panel such as PRINT, ALARM,
RIBBON and/or PAPER light or blink to indicate the problem condition.
The following table show the relation between lighting or blinking condition of
each indicator and possible cause and remedies.
Indicators
Lighting
PRINT
PRINT
RIBBON
PAPER
ALARM and PAPER
ALARM and RIBBON
ALARM
PRINT, ALARM,
PAPER and RIBBON
a) The indicator blinks slowly.
Blinking
PRINT
PRINT a)
ALARM
Possible cause and remedies
Printing
Data receiving
Adjusting the temperature of the thermal head so that the printer is
ready to print.
• Printing stops midway.
n The indicators stop lighting and blinking after the paper is ejected.
• The paper which cannot be used, with this printer has been loaded.
n Wait until the paper is ejected. Then, load the appropriate paper.
• The ribbon has been exhausted.
n Replace the old ink ribbon cartridge with the new one. The ink
ribbon cannot be reused. (page 15)
• The ink ribbon cartridge is not loaded.
n Load the ink ribbon cartridge. (page 15)
• The paper has been exhausted.
n Load the paper in the paper tray. (page 18)
• The paper tray is not installed.
n Install the paper tray.
The ink ribbon cartridge and paper are not compatible.
n Use a valid combination of paper and ink ribbon cartridge. (page 22)
• The ink ribbon cartridge is defective.
n Replace the defective ink ribbon cartridge with the new one.
(page 15)
• The ink ribbon has torn.
n Repair the tear. (page 17)
• The ink ribbon cartridge that cannot be used with the printer.
n Load the appropriate ink ribbon cartridge. (page 22)
The paper has jammed inside the printer.
n Remove the jammed paper. (page 26)
• Serviceman-call trouble occurs.
n Turn off the power immediately and contact your Sony service
facility or your Sony dealer.