KV
-XJ29M31/XJ29M50/XJ29M60/
XJ29M80/XJ29M81
RM-952
–
26
–
2-11. PICTURE TUBE REMOVAL
•
REMOVAL OF ANODE-CAP
NOTE : After removing the anode, short circuit the anode of the picture tube and
the anode cap to the metal chassis, CRT shield or carbon paint on the
CRT.
•
REMOVING PROCEDURES
1
Do not damage the surface of anode-caps with sharp shaped objects.
2
Do not press the rubber too hard so as not to damage the inside of anode-cap.
A metal fitting called the shatter-hook terminal is built into the rubber.
3
Do not turn the foot of rubber over too hard.
The shatter-hook terminal will stick out or damage the rubber.
•
HOW TO HANDLE AN ANODE-CAP
3
When one side of the rubber cap is separated from the anode button, the anode-cap
can be removed by turning up the rubber cap and pulling it up in the direction of the
arrow
c
.
2
Using a thumb pull up the rubber cap firmly in the direction indicated by the arrow
b
.
1
Turn up one side of the rubber cap in the direction indicated by the arrow
a
.
Anode button
a
a
b
b
c
0
Four DGC clips
9
Degaussing coil
6
Four claws
1
Two screws
(+P 4
×
16)
2
Speaker
Bracket
assy (L)
Speaker
(15
×
6.5 CM)
Speaker Bracket
assy (R)
4
Two screws
(Tapping)
Chassis assy
6
Deflection
yoke
7
VM1 Board
8
C6 board
3
Anode cap
5
Picture tube
Cushion
4
Two screws
(Tapping)
!£
Tension
spring
Four screws
(+BVTP 4
×
16)
Four screws
(+BVTP 4
×
16)
Four screws
(+BVTP 4
×
16)
DGC holder
DGC holder
Cushion DGC
Cushion DGC
Two screws
(+BVTP 4
×
16)
!¢
Speaker
(15
×
6.5 CM)
1
Two screws
(+P 4
×
16)
!∞
!¢
!¡
!™
