Locations and Functions of Parts
26
Chapt
er
1
Ov
er
v
ie
w
h
Battery level/external power supply
voltage and current
Displays the current power level of the battery
pack. When the battery pack is fully charged, all
seven segments light up. As the battery pack
discharges, the segments go out from left to right.
When the battery pack is almost exhausted, the
voltage indication and the tally indicator flash,
and a warning tone sounds intermittently. When
the battery pack is completely exhausted, the tally
indicator flashes at a higher rate and the warning
tone sounds continuously.
For details, see “Warning System” (page 183).
The voltage actually used by the unit (slightly
lower than the input voltage is shown.
For details on battery voltage and so on, see
“Checking the Power and Voltage” (page 29).
i
Signal formats
When you press the HOME button with the
FUNC button held down, displays the system
(SYS), playback (PB), and monitor (MON)
output signal formats, in that order from the top
row.
When the unit is in one of the following modes,
an alphabetic character indicating the mode
appears before the number of lines.
T:
Auto Timer Rec
M:
Manual Timer Rec
C:
Cache Rec
When SR Motion is used, “S” appears before the
system frequency. When you play a tape that was
recorded with SR Motion, the FPS value in SR
Motion recording is shown in the playback
frequency position
.
See Chapter 6 “SR Motion (With HKSR-9002
Installed)” (page 97) for more information about the
SR Motion function.
j
HDSDI output
When the optional HKSR-9001 is installed,
displays the signal formats of monitor output
(MON) and the output of the HD SDI OUT A/B
connectors (OUT). The display switches when
you press the HOME button with the FUNC
button held down.
See “What Are Dual Link and 3G?” (page 195) for
more information about HDSDI output.
k
SR Motion
When SYSTEM Setup >FORMAT >SELECT
FPS in the VTR menu is set to “ON” and the
signal format is being displayed, pressing both the
FUNC and HOME buttons together displays the
FPS or FRM on the second line and the memory
level on the third line.
See Chapter 6 “SR Motion (With HKSR-9002
Installed)” (page 97) for more information about the
SR Motion function.
By connecting the cable to the CTRL (CAM)
connector, you can operate the unit remotely. You
can also connect the AP-1 Assistant Panel to the
unit’s left-side panel. The AP-1 provides the same
functions as the switches and buttons on the unit’s
right-side panel.
See “Attaching the AP-1 Assistant Panel (Optional)”
(page 38) for more information about attaching the
AP-1.
Note
The cursor in the subdisplay may move
unexpectedly if you disconnect or connect the
AP-1 Assistant Panel (Optional)
1
Connection cable
2
LOCK switch
3
VF MENU/DISPLAY button
4
Assignable switches 1 to 3
5
6
RUN button and indicator
7
Assignable 4/AUTO BLK BAL switch
8
9
SET button
q;
Subdisplay
qa
MENU SEL/ENTER dial
Содержание SRW-9000
Страница 206: ...Index 206 Index ...
