— 6 —
SAT-HD100
1-1. TOP COVER REMOVAL
SECTION 1: DISASSEMBLY
1-2. CABLE DRESSING & TOP COVER RE-ASSEMBLY
1
Remove 4 screws (+ BVTP 3 x 8) from
rear of cover.
2
Gently pull cover towards back of unit to
release and remove.
1
When reattaching the top cover, be sure
not to break or damage the grounding tape
connection shown.
2
When replacing the top cover, be sure that
the FD board assembly is properly seated in
its connector.
3
Insert the cables as shown into the cable tie
prior to reattaching the top cover.
4
When replacing the top cover, be sure that
the cable connector shown is not pinched.
5
Route the excess wire connected to the RF
Block around the pins as shown to avoid
pinching or slicing the wires when the cover
is replaced. Excess wire is secured with
copper tape.
6
Route the grounding wire between the
posts as shown to avoid pinching
or slicing.
7
Insert the cables as shown into
the cable tie prior to reattaching
the top cover.
8
Route the two wire assemblies around
each other to eliminate excess slack as
shown.
1
2
1
1
5
6
7
8
2
3
4
Содержание SAT-HD100
Страница 2: ... 2 SAT HD100 ...
