Sony RM-B150, Руководство по обслуживанию

Страница: 7 / 66

1-1(E)
RM-B150
The RM-B150 is equipped with various kinds of new functions. Depending on the camera that is connect-
ed to the unit, some functions require settings by using the menu of the RM-B150 and some functions
cannot be activated. See the following table for details.
Some functions become activated if the camera is equipped with the updated ROM. If the ROM version is
not applicable, make the settings by the menu or replace the ROM as necessary.
If the menu setting is required, refer to the operation manual supplied with the RM-B150. If ROM
replacement is required, consult your Sony service organization.
Section 1
Installation
Function BVP-900/950 BVP-700/750 BVP-570 BVP-500/550 HDC-700A/750A HDC-700/750 HDW-700/700A
Filter number
auto recognition
Yes * 1 Yes * 2 Yes * 2 * 2
GAIN L/M/H select
interlocking
Yes * 1 Yes * 2 Yes * 2 * 2
Iris Open/Close value
auto recognition
Yes
*
1 Yes
*
2 Yes
*
2
*
2
White
Preset
Yes No Yes * 3 Yes * 3 * 3
VTR
Control Start/Stop
Yes No Yes * 3 Yes * 3 * 3
Except above No No No No No No * 3
Camera setup menu
operation
Yes No Yes * 3 Yes No * 3
Video monitor
output
Yes No * 4 * 4 No No * 5
* 1: These are not functioned automatically. Perform manual settings by the menu of the RM-B150.
* 2: If using these functions, check whether the ROM version for the camera/camcorder is applicable to the version shown below, or not.
If not, replace the ROM. Or perform manual settings by the menu of the RM-B150.
*
3: If using these functions, check whether the ROM version for the camera/camcorder is applicable to the version shown below, or not.
If not, replace the ROM.
*
4: Monitoring the video signals is enabled only for the BVP-550 series that is used together with the CA-570/530 series.
For the BVP-550 series that is used together with the CA-550/550P, or BVP-500/500P, monitoring is disabled.
*
5: If using these functions, check whether the ROM version for the camcorder is applicable to the version shown below, or not.
If not, replace the ROM. The output signal is the only Y signal.
Applicable ROM Version
BVP-500/550 (IC36/AT-95 board): Ver. 4.00 or higher
HDC-700/750 (IC26/IF-569 board, IC24/SG-226 board): Ver. 3.00 or higher (for both ICs)
HDW-700/700A (IC15, 16/IF-667 board): Ver. 1.24 or higher (for both ICs)