Sony PHU-220R, Руководство по эксплуатации

Страница: 19 / 28

19 Operations
O
p
er
at
io
n
s
• If the PHU connection cable is
disconnected during recording, recording
will stop. The data recorded up to that
point is stored, but integrity of such data
is not guaranteed.
• If the power is accidentally turned off
during recording, recording will stop.
However, the data recorded up to that
point is stored normally.
• The unit may stop operating if it detects
that the ambient temperature is lower or
higher than the HDD guaranteed
operation temperature range. This is done
to protect the unit. If this occurs, wait
until the ambient temperature returns to
the guaranteed operation temperature
range before trying to use the unit. See
“Specifications” (page 22) for the
guaranteed operation temperature range.
• If the unit stops responding during power
off (including automatic power off
because of low battery power), power the
unit off by pressing the power switch and
holding it for at least three seconds.
However, recorded data is not guaranteed
in this case.
Forcibly cutting power by disconnecting
the battery pack or battery charger may
damage the unit.
About the drop detection function
This unit is equipped with a 3G sensor to
protect the internal HDD when the unit is
dropped or overturned. The sensor detects
differences in acceleration and may activate
the drive protection function if you jump
down from a high place, run down a flight
of stairs, or otherwise cause the unit to
detect acceleration similar to that of the unit
being dropped. In such cases, the integrity
of the recorded data is not guaranteed. In
addition, the drive protection function may
not activate if a drop is combined with
vibration and flipping of the unit.
Playing Back Video Clips
on a Recorder
When you connect this unit to a
PMW-EX30 recorder, video clips stored on
the unit can be displayed as thumbnail
(reduced size) images and played back on
the LCD panel of the recorder.
Note
If the MODE SELECT switch is set to
[220GB], the PMW-EX30 will not
recognize the unit and playback will not be
possible.
1
Connect this unit to the BC-U1 or
BC-U2 battery charger using the DC
power output cord supplied with the
battery charger.
Connect the AC power cord of the
battery charger, and set the mode select
switch on the battery charger to the DC
OUT.
For details, refer to the operating instructions
of the battery charger.
2
Connect this unit to the recorder with
the PHU connection cable.
Insert the card of the PHU connection
cable into one of the card slots on the
recorder.
Connect the connector of the PHU
connection cable to the USB connector
on this unit.