Firmly insert the bottom edge of the DIMM into the socket.
Press evenly against the DIMM's upper corners. The end latches snap into position automatically.
Reinstall any add-in cards or components you removed.
Replace the cover and reinstall the screws, as described in
Replacing the Cover
.
Replacing the Lithium Battery
After several years, when the lithium battery starts to weaken, the system settings stored in CMOS
RAM, such as the date and time, may be wrong. When this occurs, you need to replace the lithium
battery.
To replace the lithium battery
Write down any changes you have made to the settings in the BIOS Setup utility. If you have not
made any changes to the BIOS settings, proceed to step 2.
Shut down your computer and turn off all peripheral devices, such as your printer. Unplug your
computer.
Remove the cover as described in
Removing the Cover
.
If necessary, remove any cables, add-in cards, or other components to access the lithium
battery.
Remove the old battery and install the new battery with the plus (+) side up.
There is danger of the battery exploding if it is replaced incorrectly. You must replace the battery only with a
CR2032-type lithium battery. Discard used batteries according to the instructions in the VAIO Consumer Information
Guide.
Replace the cover and reinstall the screws, as described in
Replacing the Cover
.
Page 351