Using
the IR Remote Commander
®
Unit
19
If you want to...
Pick up the IR Remote Commander
®
unit and. . .
Turn the Remote Room on.
Press the Power button.
NOTE:
To enjoy video sources, follow these additional steps.
1. Turn on the television in the room.
2. Select the appropriate video input on the television.
3. Leave the television volume all the way down. Sound will
play through the system loudspeakers.
Using the IR Remote Commander
®
unit
Your system is configured by your installer for two to six Remote Rooms. Each Remote Room constitutes a separate "zone" in the system
and is supplied with a handheld infrared Remote Commander® unit, which can operate the in-wall keypad from across the room.
NOTE:
As with other infrared remote controls, you'll get the best results when you point the IR Remote Commander unit at the units
you're controlling, which will be the In-Wall Keypad and the room television.
NOTE:
Any IR Remote Commander unit can be used with any in-wall keypad.
IMPORTANT NOTICE:
If your system distributes the video output from a single, centralized Cable TV, Satellite TV or High Definition TV
set-top box, your remote room keypad is LIMITED to a SINGLE Cable, Satellite or High Definition TV channel selected in the main room
set-top box. To get independent channel selection in every room, your installer must distribute the incoming Cable, Satellite or High
Definition TV signal to set-top boxes in every room. In this case, you can use the remote for each set-top box to select channels
independently and use the television remote control to adjust volume. Sound from a local set-top box in the remote room will be heard
only through the remote room television's built-in speakers, not the system speakers.
