Sony MVS-7000X, Быстрая настройка

Страница: 17 / 79

pg. 17
Video Inputs
The MVS-7000X has up to 80 non-looping inputs, each in blocks of 20. These can be seen in the above
photo on slots 5-8. All inputs are “mappable” from the control panel menu to any crosspoint button so
there is no need to match the physical input to where the operator would like to select it. Also, there is
no differentiation between video and key inputs. Wire key inputs to any of the input connectors.
Video/Key matching is done later in the setup menu.
Video Outputs
An MVS-7000X can have either 24 or 48 outputs. If only 24 outputs are configured, then there will be a
blank in slot #10. Please notice that Slot #9 has outputs 1-20 and in the middle of slot #11 you will find
outputs 21-24. If you have 48 outputs, then you will find Outputs 25-44 on Slot #10 and Outputs 45-48
on the right-side of slot #11. Outputs 23-24 and 47-48 have dual outputs. If there is a blank in slot 10
(switcher only has 24 outputs), then the BNC connectors for Outputs 45-48 are not functional.
Just like inputs, all outputs on the 7000X are mappable from the Setup Menu. However, the default
factory setting is:
Out 1 M/E 1 OUT 1 (M/E 1PGM)
Out 2 M/E 1 OUT 2 (M/E 1 PVW)
Out 3 M/E 2 OUT 1 (M/E 2 PGM)
Out 4 M/E 2 OUT 2 (M/E 2 PVW)
Out 5 M/E 3 OUT 1 (M/E 3 PGM)
Out 6 M/E 3 OUT 2 (M/E 3 PVW)
Out 7 P/P OUT 1 (P/P PGM)
Out 8 P/P OUT 2 (P/P PVW)
Out 9 EDIT PVW
When you are wiring outputs, please note that the EDIT PVW output is the correct output for “Preview.”
This enables the preview switcher (which is normally set to P/P PVW) to also show other M/E previews
and other important signals like “Show Key.”
Reference
The MVS-7000X requires house “black” reference to operate. If you are not looping black, please
connect a 75-ohm terminating resistor to the loop connector. Both “black” and tri-level sync are
permitted, however tri-level sync is only required for special applications, like 24P production. It is also
very important to note that BLACK reference is required when using the internal format converters. The
internal format converters will not work with tri-level sync.