Sony MVS-7000X, Быстрая настройка

Страница: 33 / 79

pg. 33
Start-up
If you have not yet done so, please plug-in and turn on all power supplies on all chassis. Please note that
the MVS-8000X switcher chassis requires at least three power supplies to be turned on to operate. The
MVS-7000X chassis requires at least two power supplies to be turned on to operate.
It will take approximately 30-45 seconds for the control panel to completely light up and about another
2 minutes for the menu display to finish initializing.
If everything has powered up correctly, you should see the LCD labels on the control panel lit up (if this
came brand new from the factory they are all likely orange colored). You should also see the menu
display operating (although it still might be saying “Initializing”). If you have a separate, detached, Aux
row (not an aux remote panel, but the main large aux row that looks like an M/E without fader arms),
that should also be lit up and the LCD labels are likely orange. If your aux row is built-in to the main
panel it should also be lit. All the rectangular LCD labels over the crosspoint buttons should have text in
them.
If things don’t look right, there are a few items to check:
1. Make sure your Ethernet switches are turned on. A symptom of no network connectivity is the
LCD labels will light but have no text at all. Another symptom of no network connectivity is
crosspoint button pushes on the panel will not change which button is lit.
2. Make sure you wired the DATA and CONTROL LANs separately, correctly and each to their own
switch.
3. Make sure the Ethernet switches are not connected to each other
4. Make sure the Ethernet switches are not connected to an outside network
5. Make sure the SWC-5005 or SWC-5010 cables (big black cables that connect the physical panel
to the SCU) are in the correct connectors on the MKS-8010B. A typical symptom of accidentally
switching the Aux panel with the Menu panel is the menu panel will not work and the aux will
light up but nothing will work. If you remove cables you MUST turn off power to the SCU first.
If everything looks good, let’s proceed to setting up the switcher with the touchscreen menu.